We built these infrared table heaters for one simple reason: some places just can’t afford to be cold, wet, and slow. Think of those freezing changing rooms—the kind where you can see your breath and your fingers go numb. Our heaters cut through that in seconds. No waiting around for air to warm up. Just direct, immediate heat that doesn’t quit when the moisture starts flying.
Here’s the power behind the warmth
Inside, you’ve got a high-density halogen element, typically running on 400V. That voltage packs serious wattage into a small footprint, so you get intense radiant heat without tripping over your industrial circuits. The science is pretty straightforward. Electricity hits the filament, and it throws off infrared heat that lands directly on people and surfaces. No heating the air. That means the warmth shows up almost instantly. You flip the switch, and boom—heat. But with that kind of power density, you do need to plan for the heat it puts out. Make sure your install has decent airflow or the right spacing. Give it room to breathe, and it’ll keep running steady.
Built tough where it counts
We wrap the halogen element in a quartz tube. Quartz handles the shock of rapid on/off cycles without cracking, and it shrugs off corrosion. Inside, halogen gas protects the filament, so the heater stays consistent and lasts longer. The waterproof coating? This isn’t just for looks. It’s a fully sealed barrier that keeps moisture out, so the electronics and the tube stay safe. And for the electrical connection, we use an R7s connector—secure, rated for high temps, and easy to service when you’re on the floor.
Where it shines: changing rooms and beyond
In changing rooms, these heaters put warmth exactly where you need it—over benches, by the entryways. The waterproof build laughs at splashes, pressure washers, and that thick, humid air. If you’re the one spec’ing it, you’ll like how straightforward it is. Small footprint. Simple mounting. And the response is immediate. It’s just as at home in other wet, humid industrial spots where you need spot heating and you absolutely can’t afford downtime.