A fake flame heater is the rare outdoor electric heater that actually earns its keep after dark—when the air turns sharp, the evening drags on, and the look of the space matters as much as the warmth. You get the glow of a real fire, but the comfort is straight infrared. No smoke, no embers, just steady radiant heat that hits people and objects directly, instead of wasting energy on the empty air between. What’s under the hood We build these around a clean infrared heat source—usually a quartz tube or a carbon fiber element—paired with a convincing LED flame effect. The payoff is immediate warmth and a strong visual anchor. Since the units are electric, we can set them up for just about anywhere: 120V for North America, 220–240V for Europe and Asia, and plug standards that cover NEMA, Schuko, Type G, and Type I. If you need a specific voltage band or a regional safety certification, we configure the heater to match, then run it through checks for stable thermostat control, tip-over protection, and the right IP rating for outdoor exposure. Global customization matters because an outdoor heating plan falls apart fast when the heater can’t plug in—or worse, when local voltage stresses the internals. With voltage-and-plug flexibility, you can stick to one heating concept across countries: consistent heat output, predictable energy draw, and the same straightforward installation steps. On a restaurant terrace, a backyard lounge, or a hotel poolside, that means fewer adapters, fewer wiring headaches, and fewer surprises when you commission the system season to season. Here’s what to keep in mind. Because the heater is built for a specific voltage and plug type, confirm your outlet and circuit capacity before you order. For continuous outdoor use, go with an IP-rated model and position it where airflow is steady but still sheltered from direct rain. The LED flame effect adds atmosphere, but it draws a small amount of power—so you’ll see a touch of extra wattage on the label alongside the main heating element.